Does my Arduino have enough power? - LEDs and Multiplexing

Hello, I recently ordered an Led matrix 32x16 RGB for my Arduino Uno. Its pretty similar to the ones that adafruit sells. Since im a software engineer but pretty bad in electrical stuff, my question is: Is the power that my Arduino Uno provides enough to power the 5V 2A Led matrix over USB? If not, can i still use it? What would happen? In case i need an external power supply, can you recommend me one, and do i have to plug the external power supply into the arduino or directly into the 5V in

RGB LED Diode Resistors/Power source to Nano - LEDs and Multiplexing - Arduino Forum

4 digits, 7 segments LED display multiplexing with Arduino

Connect Multiple I2C Devices to Arduino Using I2C Multiplexer TCA9548A

Multiplexing analog devices (RGB LEDs) with Arduino : r/arduino

Multiplexing DAC output from a Seeed Xiao : r/arduino

arduino - Keep brightness high whilst multiplexing [SOLVED] - Electrical Engineering Stack Exchange

Does my Arduino have enough power? - LEDs and Multiplexing - Arduino Forum

Arduino Prototype to Manufacturable PCB: An LED Multiplexer

Powering multiple LEDs from external power - LEDs and Multiplexing - Arduino Forum

LED Multiplexing with the MAX7219 Module

Multiplexing With Arduino and the 74HC595 : 14 Steps (with Pictures) - Instructables

Driving LEDs with a Microcontroller

Multiplexing With Arduino and the 74HC595 : 14 Steps (with Pictures) - Instructables

Four digit, 7-segment led display for Arduino based on the TM1637 driver – thesolaruniverse